OPENRIG FX · REVERB
OR Plate
A plate reverb with a frozen tail

What it does
OR Plate is a stereo plate reverb. Inside, a modulated figure-eight tank of all-pass and delay lines makes a dense, smooth tail.
You set the decay in seconds. Low decay and high decay scale it below and above two crossovers, so the low end can stay tight and the highs can fade first, like a damped plate.
Pre-delay, a low cut and a high cut shape the reverb only, never the dry note. Freeze holds the tail forever. When you bypass it, the tail rings out.
In OpenRig
A decay curve: how long the lows, mids and highs ring, drawn from the plate's own settings.
When to use it
- A short, bright plate for clean chords.
- A long, dark plate behind ambient parts.
- Freeze to hold a chord as a pad and play over it.
Controls
OR Plate · Stereo| Control | Range | Default | What it does |
|---|---|---|---|
| Decay | 0.3 s to 20 s | 2.2 s | Time the reverb takes to fall by 60 dB at middle frequencies. |
| Mix | 0 % to 100 % | 25 % | Up to 50 % the dry signal stays at unity and the reverb rises; above, the dry signal falls, to reverb only at 100 %. |
| Pre-delay | 0 ms to 250 ms | 15 ms | Gap between the dry note and the start of the reverb. A change crossfades to the new time, without a pitch bend. |
| Low decay | ×0.25 to ×2 | ×0.8 | Decay of the lows as a multiple of Decay: below 1 keeps the low end tight. |
| High decay | ×0.1 to ×1 | ×0.5 | Damping: decay of the highs as a multiple of Decay. Lower is darker, 1 is a bright metal plate. |
| Low crossover | 50 Hz to 1 kHz | 300 Hz | Frequency below which Low decay applies. |
| High crossover | 1 kHz to 12 kHz | 3.5 kHz | Frequency above which High decay applies. |
| Low cut | 20 Hz to 1 kHz | 100 Hz | High pass on the reverb only. Off at the minimum. |
| High cut | 1 kHz to 20 kHz | 20 kHz | Low pass on the reverb only. Off at the maximum. |
| Modulation | 0 % to 100 % | 30 % | Slow movement inside the plate: smooths metallic ringing, and adds a chorus-like shimmer when high. |
| Freeze | Off, On | Off | Holds the reverb as it is, endlessly, and lets no new sound in. Bypassing still lets it ring for up to 30 s. |
Presets
Values that differ from the defaults- Dark Plate
- Decay 3.5 s, Mix 28 %, Pre-delay 25 ms, High decay ×0.25, High cut 6 kHz
- Huge Shimmering Plate
- Decay 9 s, Mix 35 %, Pre-delay 40 ms, High decay ×0.6, Modulation 60 %
- Short Bright Plate
- Decay 0.9 s, Mix 22 %, Pre-delay 5 ms, Low decay ×0.6, High decay ×0.8
- Studio Plate
- The defaults