OPENRIG FX · DELAY

OR Echo

Tempo-synced echo, clean to worn

OR Echo in OpenRig: an echo timeline with decaying repeats, and rows of knobs
OR Echo in OpenRig's editor, basic look.
OR Echo and OR Plate as rack blocks with an amber edge and the OR FX mark
Basic blocks in the rack carry an amber edge and a glyph of their view.

What it does

OR Echo is a delay with three voicings. Digital gives clean repeats. Tape darkens and saturates each repeat, with wow and flutter. Analog sounds like a bucket-brigade line: the longer the time, the darker the repeats.

The time follows the tempo in note values, or is set in milliseconds. Changing it never clicks: digital crossfades, tape and analog glide like a motor or a clock.

Filters sit inside the feedback loop, so each repeat gets thinner or darker. Ducking lowers the echoes while you play and brings them back when you stop. When you bypass it, the repeats ring out.

OR Echo Stereo has a line per channel, or ping-pong echoes that alternate between the sides.

In OpenRig

An echo timeline: drag the first repeat to set the time, the second to set the feedback. Beat lines follow the tempo, and ping-pong splits the view into left and right lanes.

When to use it

  • A slapback on a clean or country part.
  • A dotted eighth synced to the song for ambient leads.
  • Ducked repeats under a solo, so the notes stay clear.
  • Feedback above 100 % for a held runaway, kept in check by the saturation and a loop limiter.

Controls

OR Echo · Mono
ControlRangeDefaultWhat it does
Time20 ms to 2000 ms400 msTime between echoes when Sync is off. Changes crossfade (digital) or glide like a tape motor or a BBD clock (tape, analog).
SyncOff, 1/1, 1/2, 1/2., 1/4, 1/4., 1/4T, 1/8, 1/8., 1/8T, 1/16, 1/16TOffNote value of the delay at the host tempo; Off uses Time.
Feedback0 % to 110 %35 %Share of each echo fed into the next. Above 100 % the echoes build up into a runaway, held by the saturation or the loop limiter.
Level0 % to 100 %40 %Level of the echoes added to the dry signal, which stays at unity.
ModeDigital, Tape, AnalogDigitalDigital: clean repeats. Tape: darkening, saturating repeats with wow and flutter. Analog: a bucket-brigade line, darker as the time grows, with a softer clip and a chorus-like modulation.
Low cut20 Hz to 1 kHz20 HzHigh pass in the feedback loop: each repeat gets thinner. Off at the minimum.
High cut1 kHz to 20 kHz20 kHzLow pass in the feedback loop: each repeat gets darker. Off at the maximum.
Modulation0 % to 100 %20 %Wow and flutter on tape, a slow chorus-like sweep on analog and digital.
Drive0 % to 100 %33 %Saturation of the tape or bucket-brigade line, from −6 to +12 dB into it (no effect on digital).
Duck0 dB to 30 dB0 dBHow far the echoes dip while the input is above the duck threshold; they come back when you stop playing.
Duck threshold−60 dB to 0 dB−30 dBInput level, dBFS, from which ducking takes effect.
DryOff, OnOnOff: echoes only, for a parallel loop. The bypass still passes the dry signal.

Presets

Values that differ from the defaults
Analog Dotted Eighth
Sync 1/8., Feedback 40 %, Level 45 %, Mode Analog, Modulation 30 %
Ducked Lead
Time 450 ms, Feedback 40 %, Level 60 %, High cut 5 kHz, Duck 15 dB, Duck threshold −36 dB
Runaway
Time 300 ms, Feedback 105 %, Mode Tape, Drive 70 %
Slapback
Time 110 ms, Feedback 10 %, Level 55 %, Mode Tape, Modulation 15 %
Tape Echo
Time 380 ms, Feedback 45 %, Level 45 %, Mode Tape, Low cut 120 Hz, Modulation 35 %, Drive 55 %

OR Echo Stereo

Stereo

The same controls as OR Echo, plus:

ControlRangeDefaultWhat it does
Ping-pongOff, OnOffEchoes of both inputs alternate between left and right.

Presets

Ducked Lead
Time 450 ms, Feedback 40 %, Level 60 %, High cut 5 kHz, Duck 15 dB, Duck threshold −36 dB, Ping-pong On
Ping-Pong Quarter
Sync 1/4, Feedback 45 %, Level 45 %, Ping-pong On
Tape Echo
Time 380 ms, Feedback 45 %, Level 45 %, Mode Tape, Low cut 120 Hz, Modulation 35 %, Drive 55 %
Wide Analog
Time 520 ms, Feedback 50 %, Mode Analog, Modulation 60 %